Independent guide. We are not an electrician or electrical contractor, we do not do electrical work and we are not for hire. Ohio licenses electrical contractors, and the City of Akron requires contractors to register for permit work. Check any electrician before you hire them · Ohio license lookup

Akron Electrician GuideIndependent guide for Akron and Summit County, Ohio · not an electrician

Start here › Lighting and fans

Lighting and ceiling fan installation in Akron

Checked November 16, 2026 · independent guide, not an electrician

Lighting jobs look small, and many are. In an older Akron house, though, a new ceiling fan can mean a plaster ceiling, a box that was never rated for a fan, and wiring from another era. This page covers what Summit County permits, which Ohio rules apply, what you can safely do yourself, and the national cost data.

Replacing a fixture versus adding one

Swapping one light fixture for another on the same box and circuit is a different job from adding a new light where there was none. A new fixture location usually means new wiring, and the County's fee schedule lists lighting and circuits as permit items.

Summit County's electrical fee schedule lists "interior/exterior lighting" at $40 each, "miscellaneous circuits" at $12 each and "miscellaneous repairs" at $40, on top of a $60 application fee and a 1% state fee. (Summit County, Electrical Permit Application) If you are not sure whether your project needs a permit, call the County's electrical clerk at 330-630-7280 before work starts. (Summit County Building Standards)

Angi's national guide lists swapping simple fixtures "like lamps or ceiling fans (with proper instructions and shut-off)" among tasks some homeowners take on, and lists rewiring and new circuits as work for a licensed electrician. (Angi, How Much Does an Electrician Cost)

Ceiling fans in older Akron houses

About 34.1% of Akron's housing units were built in 1939 or earlier. (Census Reporter, ACS 2024 5-year) Before a fan goes up in a house that old, ask the electrician whether the existing ceiling box can carry a fan or needs replacing. If the ceiling is plaster on lath, ask for the wall-repair cost up front. Angi prices lath and plaster repair at $80 to $200 per square foot. (Angi, Knob and Tube Replacement Cost)

If you open a ceiling box and find cloth-covered wire or porcelain knobs, stop and read the old house wiring guide.

Ohio rules that touch lighting

The Residential Code of Ohio, Chapter 34, adopts the National Electrical Code with Ohio amendments for one-, two- and three-family homes. (Ohio Adm. Code 4101:8-34-01) Two Ohio provisions matter for lighting work:

Source: Ohio Adm. Code 4101:8-34-01.

Low-voltage and landscape lighting

Ohio does not treat a person as an electrical contractor for work limited to systems under 50 volts, and it names landscape lighting and irrigation in that list, along with alarms, cabling, tele-data, sound and communication systems. (Ohio Revised Code 4740.13(D)) The transformer for low-voltage landscape lights still plugs into, or is wired to, a 120-volt circuit. A new outdoor 120-volt receptacle or circuit for it is line-voltage work, and Ohio requires GFCI protection on outdoor outlets. (Ohio Adm. Code 4101:8-34-01)

Finished basements and new rooms

The City of Akron says finishing a basement requires permits, issued by Summit County. (City of Akron, Plans and Permits) For an alteration like that, the County's published fee is $2 per 100 square feet for interior alterations, plus the application fee. (Summit County, Electrical Permit Application) Ask the County how the lighting, switches and receptacles in the project will be listed on the permit.

What lighting work costs (national figures)

No published Akron-specific lighting prices were found. Angi's 2026 national figures:

Job National range
Install a light fixture $155 to $955
Install a ceiling fan $140 to $350
Install an attic fan $370 to $915
Install a light switch $100 to $200
Smart fixtures $200 to $300
Home automation $200 to $1,660

Source: Angi, How Much Does an Electrician Cost. Angi's knob-and-tube page gives similar per-item numbers: $160 to $950 per light fixture and $150 to $360 per ceiling fan. (Angi, Knob and Tube Replacement Cost)

Angi's fixture range is wide, so ask whether a quote includes the fixture itself. Angi also notes that electricians charge a minimum visit of one to four hours, so grouping several lighting jobs into one visit lowers the cost per item. (Angi)

Before you start

  1. Turn the circuit off at the breaker, not just the wall switch, and test that it is dead.
  2. Check the box rating if a fan or heavy fixture is going up.
  3. Decide whether you are replacing or adding. Adding usually means new wiring and a permit.
  4. If anyone else will do the work, check their license with the check an Akron electrician page.

Frequently asked questions

Do I need a permit to replace a light fixture in Akron?

The County's form lists lighting as a permit item. For a like-for-like swap on an existing box, ask the County electrical clerk. (Summit County Building Standards)

Does a landscape lighting installer need an electrical license?

Not for work limited to systems under 50 volts, under Ohio Revised Code 4740.13(D). (Ohio Revised Code 4740.13)

Who inspects new lighting in a finished basement?

Summit County's electrical inspectors. (City of Akron, Plans and Permits)

Verify before you hire

Sources

  1. Angi, How Much Does an Electrician Cost
  2. Angi, Knob and Tube Replacement Cost
  3. Summit County, Electrical Permit Application
  4. Summit County Building Standards
  5. Ohio Adm. Code 4101:8-34-01
  6. Ohio Revised Code 4740.13(D)
  7. City of Akron, Plans and Permits
  8. Census Reporter, ACS 2024 5-year