Start here › Panel upgrades
Electrical panel upgrades in Akron
Checked November 16, 2026 · independent guide, not an electrician
A panel upgrade is the electrical job where Akron's rules matter most. It touches the service from Ohio Edison, so in Summit County a homeowner may not do the service part, the County must inspect it, and the power stays off until the inspection passes. This page covers when an upgrade makes sense, how the permit and reconnection work, and what the published cost data say.
Why so many Akron panels are due
More than half of Akron's housing was built before 1960. The Census Bureau's 2020-2024 estimates count 56,036 of the city's 93,741 units, about 59.8%, as built in 1959 or earlier, and only about 2.5% as built since 2010. (Census Reporter, ACS 2024 5-year, table B25034) Houses of that age were wired long before central air, induction ranges and car chargers.
Angi's national data say most wiring and panel projects (65.7%) are upgrades to existing service, typically after new appliances, an EV charger, or constant breaker trips. (Angi, Cost to Upgrade an Electrical Panel)
Common reasons Akron owners start the conversation:
- A fuse box or a panel with no free spaces.
- Breakers that trip when the microwave and a space heater run together.
- Plans for a Level 2 EV charger, a hot tub, central air or a heat pump.
- An insurer or a home inspector who flagged the panel during a purchase.
What size of service
Angi describes 200 amps as the current standard for homes and as generally enough for a house of up to about 1,800 square feet, while large loads such as central air, hot tubs or saunas may call for 300 or 400 amps. (Angi) Ask the electrician to do a load calculation for your house rather than picking a size by habit.
One detail catches people out. A master electrician quoted by Angi points out that a new 200-amp panel connected to an exterior wire and meter box rated for only 100 or 150 amps will not deliver its full rating. Those parts also need upgrading. (Angi)
Who may do the work in Summit County
Summit County lets owners pull permits for some electrical work on their own homes, but not this part. Its code lists "installation of or repair of an electrical service/meter from the utility connection to the structure" among the jobs that must be done by a state-licensed contractor. (Summit County Codified Ordinances 1305.06) Ohio Edison's ownership guide puts the meter base, the service entrance cable and the panel on the owner's side, and the service drop and meter on the utility's side. (Ohio Edison, Who Owns What?) Check the contractor's license with the steps on the check an Akron electrician page.
Permit, inspection and turn-on
The sequence for a typical Akron service upgrade:
- The contractor applies to Summit County. The County's fee schedule lists a $60 residential application fee and $40 per service upgrade, plus $12 per added circuit and a 1% state fee. (Summit County, Electrical Permit Application)
- The contractor sends the service diagram. The County's residential forms include an Overhead Electrical Service Diagram and an Underground Service Diagram. (Summit County, Residential Forms)
- The old service is disconnected and the new one installed.
- Summit County inspects. The City of Akron notes that the power company will not turn power back on until the service is inspected, and that Summit County Building Standards does that inspection (330-630-7280). (City of Akron, Plans and Permits)
- Power turn-on. The County publishes a Power Turn On Request form. (Summit County, Residential Forms)
Ask the contractor how long your house will be without power and whether the inspection is booked for the same day. If it is not, plan for a night away, especially in winter.
Ohio code points that show up at inspection
The Residential Code of Ohio adopts the National Electrical Code with Ohio amendments. Two that touch panel jobs: Ohio dropped the NEC requirement for a receptacle within 25 feet of indoor service equipment in one-, two- and three-family dwellings, and it rewrote the surge-protection rule for dwelling services so it applies "where provided." (Ohio Adm. Code 4101:8-34-01) If you want whole-house surge protection, ask the electrician to price it as its own line.
What it costs (national figures)
These are national 2026 figures from Angi. No published Akron-specific panel prices were found.
| Panel size | Panel only | Panel plus installation |
|---|---|---|
| 100 amps | $100 to $200 | $800 to $1,500 |
| 150 amps | $150 to $250 | $1,300 to $1,600 |
| 200 amps | $250 to $350 | $1,300 to $2,000 |
| 300 amps | $350 to $500 | $1,800 to $3,500 |
| 400 amps | $500 and up | $2,000 to $4,000 |
Source: Angi, Cost to Upgrade an Electrical Panel. Angi's national average for a panel upgrade is $1,600, with most homeowners paying $1,200 to $2,000.
Related national figures from the same page: a subpanel costs $400 to $1,750, a meter box installation or replacement $200 to $800, and fuse box replacement $200 to $2,000. (Angi)
Against Angi's national permit estimate of $50 to $300 for a panel, the published Summit County fees for a service upgrade with no added circuits come to $100 before the state fee. (Summit County, Electrical Permit Application)
Before the electrician arrives
- Clear the area in front of the panel. Angi suggests clearing space to improve access. (Angi)
- Label which rooms each breaker controls, if they are not labeled.
- Plan for any medical equipment, freezers and sump pumps that will be without power.
- If you smell gas near the meter area at any point, leave and, from a safe place, call 911 and your gas utility. Enbridge Gas Ohio's emergency line is 1-877-542-2630. (Enbridge Gas Ohio)
Frequently asked questions
Can I replace my own panel in Akron?
The service and meter portion must be done by a state-licensed contractor under Summit County code 1305.06. (Summit County Codified Ordinances)
Do I need City of Akron approval for a panel swap?
Summit County issues the electrical permit inside Akron, but the City says the County cannot issue permits without Akron Approval, and contractors doing permit work must be registered with the City. (City of Akron, Plans and Permits)
Does Ohio require a whole-house surge protector?
Ohio's amendment applies the NEC surge rule for dwelling services "where provided." (Ohio Adm. Code 4101:8-34-01)
Verify before you hire
Sources
- Angi, Cost to Upgrade an Electrical Panel
- Summit County, Electrical Permit Application
- Summit County, Residential Forms
- Summit County Codified Ordinances 1305.06
- City of Akron, Plans and Permits
- Ohio Adm. Code 4101:8-34-01
- Census Reporter, ACS 2024 5-year, table B25034
- Enbridge Gas Ohio
- Ohio Edison, Who Owns What?